Advanced Search
Trumpet, B-flat, low pitch
Maker: Henri Selmer
Date: 1938-1939 ca.
Place Made:Paris, France, Europe
Model: Model 21
Serial No: 2255
SignedStamped on bell: QUALITÉ / ARTISTIQUE / HENRI / SELMER / PARIS / DÉPOSÉ / GRANDS PRIX / GENÈVE 1927 BARCELONE 1929 / LIÈGE 1930 / H. Selmer. / 4. PLACE DANCOURT / PARIS / MADE IN FRANCE
MarkingsStamped on second valve casing: HENRI / SELMER / PARIS / 2255 / PAT. PENDING
Stamped on receiver ferrule: BB / LB / LP / 21
Stamped on valve casings, caps and stems, respectively: 1, 2, 3
Stamped on receiver ferrule: BB / LB / LP / 21
Stamped on valve casings, caps and stems, respectively: 1, 2, 3
DescriptionBrass, nickel-silver (leadpipe, inner slides, thumb hook, finger buttons and lower valve-cap rims), mother-of-pearl inlay (finger buttons), single loop, main tuning slide at first bow, three Périnet valves (1, ½, 1½), valve casing with sleeves, top-sprung, spring inside hollow stem, alignment by two unequal lugs on spring anchor plate, nickel-silver pistons, single water keys at main tuning slide and third valve slide, trigger with thumb hook at first valve and with adjustable pull-ring at third valve, windway 3-2-1.
The patent referred to on the second valve casing is US Patent No. 2,181,346, filed by Henri Selmer on July 10, 1937, and granted November 28, 1939. The objective of this patent was not to hard-solder any tubing with high temperatures directly onto the valve casing to avoid its deformation. The solution was to hard-solder the tubing onto a sleeve surrounding the valve casing. This sleeve was then soft-soldered with lower temperatures onto the valve casing, and could be easily removed for repair.
The patent referred to on the second valve casing is US Patent No. 2,181,346, filed by Henri Selmer on July 10, 1937, and granted November 28, 1939. The objective of this patent was not to hard-solder any tubing with high temperatures directly onto the valve casing to avoid its deformation. The solution was to hard-solder the tubing onto a sleeve surrounding the valve casing. This sleeve was then soft-soldered with lower temperatures onto the valve casing, and could be easily removed for repair.
DimensionsHeight: 478 mm
Tube length: 1312 mm
Bore diameter (initial, minimum, tuning slide, valve slides): 10.9 mm, 8.8 mm, 11.6 mm, 11.6 mm
Bell diameter: 120 mm
Tube length: 1312 mm
Bore diameter (initial, minimum, tuning slide, valve slides): 10.9 mm, 8.8 mm, 11.6 mm, 11.6 mm
Bell diameter: 120 mm
ProvenancePurchased from Vincent DiMartino, Danville, Kentucky, 1997.
Terms
Credit Line: Joe R. and Joella F. Utley Collection, 1999
Not on view
Object number: 07150